P2400 DYNAMOMETER

900 BHP/2000 lb./ft.

The P2400 unit is designed for testing diesel engines up to 900 BHP and 2000 lb/ft of torque. As with the P1200 it can be used in the conventional floor mounted manner, or directly attached to the engine bell housing. The latter allows minimum civil engineering cost to be incurred. The unit can be supplied with a double mechanical seal arrangement if extended no load testing is required and can be operated in single rotor mode for engines up to 520 BHP

Specification:

Type of Absorption Water
Water requirement 70 gpm @ 45 psi
Bearings Roller type grease filled and sealed
Operating RPM range 300-3000
Torque transducer Strain gauge
Speed sensing 60 tooth wheel with inductive pick-up
Drive attachment SAE 4-½ bell housing adapter
(SAE 0-00 optional)
10 ½" - 10" nominal clutch diameter flywheel drive plate and torsional damper assembly
Material Shaft EN 24T
Housing & rotor Aluminium alloy

Dyno attachments SAE - 0.5 - 4
Double Trunnion Double Roller bearing

The dynamometer is of compact design and can be used:

Direct on engine
Floor mounted (with drive shaft)
In chassis

P 1200

P 4000