P1200 DYNAMOMETER

500 BHP/1000 lb./ft.

The P1200 absorption unit is designed for testing Diesel engines up to 520 HP and 1000 lb/ft of torque. The unit can be used in the conventional floor mounted method, or directly attached to the engine bell housing. The latter allows minimum civil engineering cost to be incurred. The unit can be supplied with a double mechanical seal arrangement if extended load testing is required.

Specifications:

Type of Absorption:
Water

Water requirement:
35 gpm @ 45 psi

Bearings:
Roller type grease filled and sealed

Operating RPM range:
300-3000

Torque transducer:
Strain gauge

Speed sensing:
60 tooth wheel with sensor

Drive attachment:

SAE 4-½ bell housing adapter

(SAE 0-00 optional)

10 ½ " - 10" nominal clutch diameter flywheel drive plates and torsional damper assembly
Material: Shaft
EN 24T

Housing & rotor Aluminium alloy

Dyno attachments: SAE - 0.5 - 4

Single or Double Trunnion Double Roller bearing
The Dynamometer is of compact design and can be used:

Direct on engine
Floor mounted (with drive shaft)
In chassis

P 2400

P 4000